The I-beam wheel can be divided into metal I-beam wheels and plastic I-beam wheels based on different materials. How much do you know about metal I-beam wheels? The structure of the metal I-beam wheel winding machine includes a frame, with a lifting mechanism set on the frame. One side of the lifting mechanism is equipped with a drive top device, and the other side has a movable top device. Above the lifting mechanism, there is a light rod wire laying device. Wuxi Qinfeng Machinery Factory reminds everyone to use metal I-beam wheels according to regulations and ensure appropriate tension during operation.I-beam wheel manufacturers

Its characteristics include: the lifting mechanism consists of a bracket installed on one side of the frame, while the other side of the frame is equipped with a guide wheel and a second guide wheel. Below the guide wheel and the second guide wheel, there are a pulley and a second pulley installed; the steel wire rope is wound around the guide wheel, the second guide wheel, the pulley, and the second pulley, with both ends of the steel wire rope fixed to the bracket. A nut seat is set on the steel wire rope between the pulley and the second pulley, which is sleeved on the screw rod. One end of the screw rod is connected to the power output end of the reduction motor, and the other end is installed in the screw rod seat through a bearing. The structure is compact and reasonable, and the operation is convenient.I-beam wheel manufacturersThe lifting process of the wheel and the winding process are stable, with good winding quality.

Precautions during the operation of the cold-rolled ribbed steel bar production line

1. Lubricate the equipment before operation.

2. First, turn on the fan of the torque motor during operation.

3. Open the winding, then turn on the main machine. The machine should be tightened, and the main machine should be started promptly after winding the steel bar (within 5 seconds); otherwise, the winding motor may burn out due to excessive load.

4. The tension of the winding is appropriate. Excessive winding tension leads to: (1) accelerated wear of the main machine's traction roller, and the steel bar may squeeze the wire. Excessive tension on the winding motor leads to excessive current, causing the torque motor to burn out. The control of winding tension is based on the principle that the steel bar does not slide on the pulling drum.I-beam wheel manufacturers

The I-beam wheel should not be pushed too tightly; otherwise, the bearing force of the movable cone head will be too large and may be damaged.

During operation, check whether the movable cone head of the winding machine rotates flexibly and whether it rotates normally with the I-beam wheel. If the movable cone head does not rotate with the I-beam wheel, the torque motor will burn out due to excessive load. I-beam wheel manufacturers.

When stopping the machine, first stop the main machine, then promptly stop the winding machine, reset the torque motor controller to zero, turn the switch to the OFF position, and press the stop button. Otherwise, a small amount of current will pass through the torque motor, which will burn out the motor after a long time. The bundling of cold-rolled ribbed steel bars is part of the cold-rolled ribbed steel bar production line, and its winding force is provided by itself. Winding machines are also divided into winding and vertical winding machines, but in terms of current market sales, winding occupies most of the market.I-beam wheel manufacturers

The above content outlines the precautions during the use of metal I-beam wheels. Staff must check and operate according to the specifications to avoid faults during operation and reduce work efficiency.

Mailbox:​
wangyumei630@163.com

Tel:
086-769-85707005

Mobile:
086 132 6843 4928

Address:
Building 3, Wanshan Factory, No. 38 Hulin Road, Humen Town, Dongguan City